FT245B-style FIFO interface option with bidirectional data bus and simple 4 wire handshake interface.Enhanced bit-bang Mode interface option with RD# and WR# strobes.Option for transmit and receive LED drive signals on each channel.FTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.Fast Opto-Isolated serial interface option.MCU host bus emulation mode configuration option.CPU-style FIFO interface mode simplifies CPU interface design.Single channel synchronous FIFO mode for transfers upto 40 Mbytes/Sec.USB to parallel FIFO transfer data rate up to 8 Mbyte/Sec.(RS232 Data Rate limited by external level shifter). RS232/RS422/RS485 UART Transfer Data Rate up to 12Mbaud.Dual independent UART or FIFO or MPSSE ports.Dual Multi-Protocol Synchronous Serial Engine (MPSSE) to simplify synchronous serial protocol (USB to JTAG , I2C, SPI or bit-bang) design.USB 2.0 High Speed (480Mbits/Second) and Full Speed (12Mbits/Second) compatible.No USB specific firmware programming required. Entire USB protocol handled on the chip.Single chip USB to dual serial / parallel ports with a variety of configurations.It has the capability of being configured in a variety of industry-standard serial or parallel interfaces. The FT2232H is a USB 2.0 High Speed (480Mb/s) to UART/FIFO IC.
The FT2232H is FTDI’s 5th generation of USB devices. Frequently asked questions about FT2232HL
0 kommentar(er)
